SARGENT Passport 1000 PG Exit Devices - Manual (Page 17)

Fig. 4A
Wire
cover
(2) #6 x ½” flat head security
Torx wood screws
This side down
Inside of door
Chassis
cover
(4) #8 - 32 x 5/16”
Oval head machine
screws
Mortise Installation Instructions (Continued)
3 – Chassis Cover Instructions
Secure chassis cover to chassis using
(4) #8 - 32 x 5/16” oval head machine screws.
Note: Required for 12- Fire Rated doors only.
1. Align wire cover plate with chassis side against exit chassis
cover and mark hole positions.
2. Drill (2) 3/32” dia. by 1/2” deep holes as shown.
3. Stamped side of plate goes against door.
4. Secure wire cover plate to door directly above chassis cover
(note orientation) using two (2) #6 x 1/2” flat head security
torx wood screws.
Note: Position lower edge of cover plate against the chassis
cover to ensure no wires are visible.
(2) 3/32” dia.
by 1/2” deep
holes
Inside of door
Back side of
wire cover plate
4 - Wire Cover Instructions (Wood Door Only)
10/31/12
A7809B 17
Copyright © 2012, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
Passport 1000 PG Exit Device