SARGENT Passport 1000 PG Exit Devices - Manual (Page 7)

6
Controller
cutout
ET through bolt
hole
Cylinder
hole
Lever hole
Installation Instructions for 8977/8978 Rim Exit
IMPORTANT: BEFORE STARTING
• This device is non-handed.
• Door should be fitted and hung.
• Verify box label for size of exit device, function and hand.
If using a mullion, install in frame.
Outside of door
Fig. 1A
Inside of door
ET through bolt hole
Chassis mount
holes
Lever hole
Cylinder hole
ET through bolt holes
Wire run channel
(wood door)
Controller cutout
Mounting plate holes
ET through bolt
holes
ET through bolt
hole
ET through bolt hole
1 – Exit Hardware & Door Preparation
Prior to installation, all holes must be free of burrs, debris and sharp edges.
If doors are not properly reinforced per ANSI 115.2, commercially available reinforcements should be installed.
Prepare door according to appropriate template:
• Field template A7951 (or wood doors).
• Manufacturer’s template 4630 (for metal doors).
7 A7809B
Copyright © 2012, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
10/31/12
Passport 1000 PG Exit Device