SARGENT Passport 1000 PG Exit Devices - Manual (Page 18)

Cables
3. Attach grounding lug to bottom right screw. Position upright as shown (Fig.5B2).
4. Insert remaining corner screws and tighten all, fastening
the outside escutcheon to the door (Fig.5B1).
Fig. 5B1
Mounting plate
(4) #8 32 x
1-7/8” flat head
machine screws
Attach
ground lug
to bottom
right screw
Fig. 5B2
Fig. 5C
Mounting
plate
Position lug
upright,
then tighten
screw
(2) #8 3/8” flat head
wood screws or
(2) #8 3/8” flat
head machine
screws
Passport
gasket
Outside
Passport
trim
Fig. 5A
Note: For non-fire rated door applications, an optional gasket may be used
as a weatherseal between the escutcheon and the outside door surface.
Peel off adhesive backing and attach to (outside) escutcheon (Fig. 5A).
Outside of door
1. Insert the mounting posts through holes as shown (Fig.5B1).
2. On the inside of the door, position the mounting plate over the indicated holes. As you feed controller, keypad,
battery and grounding cables through the side opening (Fig.5B1), tuck the ferrite bead carefully under the reader.
Note: Insert either of the top corner screws to hold the plate as you feed the cables through.
Also refer to Step 6B.
Inside of door
Outside Passport
trim
Attach two (2) #8 x 3/8” flat head wood screws for wood
doors, or (2) #8-32 x 3/8” flat head machine screws for
metal doors (Fig.5C).
Tighten securely.
Mortise Installation Instructions (Continued)
5A – Installation of Outside Escutcheon with Weatherseal
Gasket (optional)
5B – Installation of Outside Escutcheon & Mounting
Plate Assembly
Inside of door
5. IMPORTANT: If the following step is skipped,
the product will not be UL-compliant:
18 A7809B
Copyright © 2012, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
10/31/12
Passport 1000 PG Exit Device