ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 151)

Communication 4-33
9. Install the External Power Kit (p/n 3800-0181) in the EMU in
the following way:
External Power Kit includes an external power cable (top) and a chassis
cable (bottom)
 Remove the plug at the top of the EMU to the right of the
communication cable entry fitting.
 Remove the nut from the metal connector on the chassis
cable (from the kit), and lubricate the O-ring on the
connector with Parker-O-Lube.
 Run the connector up through the hole at the top right of
the EMU from the inside out. Make sure the O-ring seats
properly into the grove on the inside of the EMU.