ADS Environmental Services IETG FlowHawk QR 775012 A4 - Manual (Page 308)

8-24 IETG FlowHawk Manual
address is printed directly on the SIM card or on a label
affixed to the card.
 Gently insert the new card into the slot on the SIM card
carrier in the GSM module. Orient the card so that the
beveled corner of the card will align with the beveled
corner of the carrier.
 Close the clip to the carrier, and slide the clip forward to
lock the SIM card into place.
7. Check the gasket and all edges of the module enclosure seal to
make sure they are free of any debris.
8. Replace the cover to the module, and then replace and tighten
the screws until the edges of the box are flush together.
However, do not over-tighten the screws!
9. (applicable only when replacing the SIM card) Temporarily
re-connect the communication cable from the GSM module to
the COMM port on the monitor. Then, activate the diagnostic
codes to test communications and the module based on the
instructions under Obtaining Diagnostic Codes from the
Monitor on page 8-4. Once complete, disconnect the cable
before installing the module back into the manhole.
10. Wrap electrical tape tightly over the seam (between the cover
and the case) of the GSM module enclosure. This enhances the
seal and simplifies the removal of debris the next time the
module is opened.
11. Re-attach the GSM module to the manhole wall, and recoil and
secure the antenna cable to the cable tie mount using a cable
tie. Refer to Installing the GSM Module in Chapter 4,
Communication, for more information.
12. Attach the communication cable connector from the GSM
module to the COMM port on the monitor.
13. Wrap rubber stretch tape around the entire cable connection,
extending the tape 1 to 2 inches onto the cable beyond the
connection.