Dell PowerVault DR6000 - Manual (Page 7)

1
About Your System
Front-Panel Features And Indicators
The following topic describes the front-panel features and indicators of the Dell DR6000 system.
Figure 1. Front-Panel Features and Indicators
Item Indicator, Button, or
Connector
Icon Description
1 Diagnostic indicators The diagnostic indicators light up to display error
status.
2 System identification
button The identification buttons on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the system status indicator on the back
flashes until one of the buttons is pressed again.
Press to toggle the system ID on and off.
If the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset the iDRAC (if not disabled in F2 iDRAC
setup) press and hold the button for more than 15
seconds.
3 Power-on indicator,
power button The power-on indicator lights when the system
power is on. The power button controls the power
supply output to the system.
NOTE: On Advanced Configuration and
Power Interface (ACPI)-compliant operating
systems, turning off the system using the
power button causes the system to perform a
graceful shutdown before power to the
system is turned off.
7