Installing the hard-drive backplane (back) – Dell PowerVault DR6000 User Manual
Page 78
Figure 43. Cabling Diagram—Optional 2.5 Inch (x2) Hard-Drive Backplane (back)
1.
PCIe card holder
2. hard-drive backplane (back)
3. system board
4. integrated storage controller card
5. SAS connector on the system board
6. cable retention bracket
7.
x12 or x24 hard-drive backplane
Installing The Hard-Drive Backplane (Back)
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet.
2. Open the system.
3. Align the notches on the backplane with the notches on the chassis.
4. Lift the release pin and slide the backplane on the chassis until firmly seated.
5. Release the release pin to lock the backplane to the chassis.
78