Dell PowerEdge R410 - Manual (Page 102)

102
Installing System Components
Expansion-Card Riser
The system’s expansion-card riser supports an x16 link Gen1 or Gen2 PCIe
expansion card. (An additional slot on the riser is reserved for use by the
integrated storage controller card.)
Removing an Expansion-Card Riser
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 82.
3 If installed, remove the expansion card from the expansion slot, now. See
"Removing an Expansion Card" on page 99.
4 If installed, remove the integrated storage controller card. See "Removing
the Integrated Storage Controller Card" on page 100.
5 To remove the expansion-card riser, grasp the riser guides and lift the
expansion-card riser from the chassis. See Figure 3-13.
book.book Page 102 Tuesday, March 31, 2009 5:26 PM