Dell PowerEdge R410 - Manual (Page 47)

About Your System
47
Plug & Play
Configuration
Error
Error encountered in
initializing PCIe device;
faulty system board. Install the NVRAM_CLR
jumper in the clear position
(pins 1 and 3) and reboot the
system. See Figure 7-1 for
jumper location. If the
problem persists,
see "Troubleshooting
Expansion Cards" on
page 159."
Quad rank DIMM
detected after
single rank or
dual rank DIMM in
socket.
Invalid memory
configuration. Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module Installation
Guidelines" on page 119.
Read fault
Requested sector
not found
The operating system cannot
read from the hard drive,
optical drive, or USB device,
the system could not find a
particular sector on the disk,
or the requested sector is
defective. Replace the optical medium,
USB medium, or USB
device. Ensure that the USB
cables, SAS/SATA backplane
cables, or optical drive cables
are properly connected.
See "Troubleshooting a USB
Device" on page 146,
"Troubleshooting an Optical
Drive" on page 155, or
"Troubleshooting a Hard
Drive" on page 156 for the
appropriate drive(s) installed
in your system.
SATA Port x
device not
found
There is no device connected
to the specified SATA port. Information only.
Table 1-3. System Messages (continued)
Message Causes Corrective Actions
book.book Page 47 Tuesday, March 31, 2009 5:26 PM