Installing an idrac6 enterprise card – Dell PowerEdge R410 User Manual
Page 109
Installing System Components
109
3 To remove the iDRAC6 Express card:
a
Pull back slightly on the retention standoff tab at the front edge
of the card and gently lift the card off the retention standoff. See
Figure 3-20.
As the holder releases from the standoff, the connector under the card
disengages from the system board connector.
b
Angle the card so that the notch on the card slips through the clip on
the system board.
4 Close the system. See "Closing the System" on page 83.
5 Reconnect the system and peripherals to their power sources, and turn
them on.
Integrated Dell Remote Access Controller 6
(iDRAC6) Enterprise Card (Optional)
Installing an iDRAC6 Enterprise Card
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 82.
3 Remove the system board shroud. See "Removing the System Board
4 Remove the plastic filler plug for the iDRAC6 Enterprise port from the
system back panel.
book.book Page 109 Tuesday, March 31, 2009 5:26 PM