Installing a hot-swap hard drive, Lease the drive. see figure 3-5 – Dell PowerEdge R410 User Manual
Page 86
86
Installing System Components
Figure 3-5.
Removing and Installing a Hot-Swap Hard Drive
Installing a Hot-Swap Hard Drive
CAUTION:
Use only hard drives that have been tested and approved for use with
the SAS/SATA backplane.
CAUTION:
When installing a hard drive, ensure that the adjacent drives are fully
installed. Inserting a hard-drive carrier and attempting to lock its handle next to a
partially installed carrier can damage the partially installed carrier's shield spring
and make it unusable.
CAUTION:
Ensure that your operating system supports hot-swap drive
installation. See the documentation supplied with the operating system.
CAUTION:
Combining SATA and SAS hard drives in the same system
configuration is not supported.
1
release button
2
hard-drive carrier handle
1
2
book.book Page 86 Tuesday, March 31, 2009 5:26 PM