Removing a hard drive from a hard-drive carrier – Dell PowerEdge R410 User Manual
Page 87
Installing System Components
87
1 Remove the front bezel. See "Removing and Replacing the Optional Front
2 If a drive blank is present in the bay, remove it. See "Removing a Drive
3 Install the hot-swap hard drive.
a
Press the button on the front of the drive carrier.
b
Insert the hard-drive carrier into the drive bay until the carrier
contacts the backplane.
c
Close the handle to lock the drive in place.With the lever on the hard
drive carrier open, slide the hard drive into the drive bay until the
carrier contacts the backplane (see Figure 3-5).
Removing a Hard Drive From a Hard-Drive Carrier
Remove the screws from the slide rails on the hard-drive carrier and separate
the hard drive from the carrier. See Figure 3-6.
book.book Page 87 Tuesday, March 31, 2009 5:26 PM