Dell PowerEdge R410 - Manual (Page 114)

114
Installing System Components
Replacing a Cooling Fan
1 Ensure that the fan is oriented correctly.
Orient the fan module so that the side with the power cable faces towards
the back of the system.
2 Slide the fan module into the fan assembly until the fan is fully seated. See
Figure 3-18.
3 Connect the fan’s power cable to the power connector on the system
board.
4 Replace the system board shroud. See "Installing the System Board
Shroud" on page 106.
5 Close the system. See "Closing the System" on page 83.
6 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
Optical Drive
An optional slimline DVD or DVD-RW optical drive slides into the front panel
and connects to the SATA controller on the system board.
NOTE:
DVD devices are data only.
Removing an Optical Drive
WARNING:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 If installed, remove the optional front bezel. See "Removing and Replacing
the Optional Front Bezel" on page 81.
2 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
book.book Page 114 Tuesday, March 31, 2009 5:26 PM