Kontron AT8402 CLI - Manual (Page 100)

Switching Commands AT8402
AT8402 CLI Reference Manual Page 2 - 68
2.16.5 port-security mac-address move
This command converts dynamically locked MAC addresses to statically locked
addresses.
Format port-security mac-address move
Mode Interface Config
2.16.6 show port-security
This command displays the port-security settings. If you do not use a parameter, the
command displays the settings for the entire system. Use the optional parameters to
display the settings on a specific interface or on all interfaces.
Format
show port-security
[{<slot/port> | all}]
Mode Privileged EXEC
Admin Mode Port Locking mode for the entire system. This field displays if you do
not supply any parameters.
For each interface, or for the interface you specify, the following information appears:
Admin Mode Port Locking mode for the Interface.
Dynamic Limit Maximum dynamically allocated MAC Addresses.
Static Limit Maximum statically allocated MAC Addresses.
Violation Trap Mode Whether violation traps are enabled.
2.16.7 show port-security dynamic
This command displays the dynamically locked MAC addresses for the port.
Format
show port-security dynamic <
slot/port
>
Mode Privileged EXEC
MAC Address MAC Address of dynamically locked MAC.
2.16.8 show port-security static
This command displays the statically locked MAC addresses for port.
Format show port-security static <slot/port>
Mode Privileged EXEC
MAC Addres MAC Address of statically locked MAC.
2.16.9 show port-security violation
This command displays the source MAC address of the last packet discarded on a
locked port.
Format
show port-security violation <
slot/port
>
Mode Privileged EXEC
MAC Address MAC Address of discarded packet on locked port.