High voltage safety instructions, Special handling and unpacking instructions, General instructions on usage – Kontron AT8402 CLI User Manual
Page 19: At8402 preface
AT8402
Preface
Page xix
AT8402 CLI Reference Manual
Your new Kontron product was developed and tested carefully to provide all features necessary
to ensure its compliance with electrical safety requirements. It was also designed for a long
fault-free life. However, the life expectancy of your product can be drastically reduced by
improper treatment during unpacking and installation. Therefore, in the interest of your own
safety and of the correct operation of your new Kontron product, you are requested to conform
with the following guidelines.
High Voltage Safety Instructions
Special Handling and Unpacking Instructions
Do not handle this product out of its protective enclosure while it is not used for operational
purposes unless it is otherwise protected.
Whenever possible, unpack or pack this product only at EOS/ESD safe work stations. Where a
safe work station is not guaranteed, it is important for the user to be electrically discharged
before touching the product with his/her hands or tools. This is most easily done by touching a
metal part of your system housing.
It is particularly important to observe standard anti-static precautions when changing
piggybacks, ROM devices, jumper settings etc. If the product contains batteries for RTC or
memory back-up, ensure that the board is not placed on conductive surfaces, including anti-
static plastics or sponges. They can cause short circuits and damage the batteries or conductive
circuits on the board.
General Instructions on Usage
In order to maintain Kontron’s product warranty, this product must not be altered or modified in
any way. Changes or modifications to the device, which are not explicitly approved by Kontron
Modular Computers GmbH and described in this manual or received from Kontron’s Technical
Support as a special handling instruction, will void your warranty.
Warning!
All operations on this device must be carried out by sufficiently skilled per-
sonnel only.
Caution, Electric Shock!
Indicates that you must enter a value in place of the brackets and text inside
them. Before installing your new Kontron product into a system always
ensure that your mains power is switched off. This applies also to the
installation of piggybacks.
Serious electrical shock hazards can exist during all installation, repair and
maintenance operations with this product. Therefore, always unplug the
power cable and any other cables which provide external voltages before
performing work.
ESD Sensitive Device!
Electronic boards and their components are sensitive to static electricity.
Therefore, care must be taken during all handling operations and inspec-
tions of this product, in order to ensure product integrity at all times.