4 set igmp groupmembership-interval, 5 set igmp maxresponse, Switching commands at8402 – Kontron AT8402 CLI User Manual

Page 94

Advertising
background image

Switching Commands

AT8402

AT8402 CLI Reference Manual

Page 2 - 62

Format

set igmp fast-leave

Mode

Interface Config

Format

set igmp fast-leave

<vlan_id>

Mode

VLAN Config

2.15.3.1

no set igmp fast-leave

This command disables IGMP Snooping fast-leave admin mode on a selected
interface.

Format

no set igmp fast-leave

Modes

Interface Config

Format

no set igmp fast-leave

<vlan_id>

Mode

VLAN Config

2.15.4

set igmp groupmembership-interval

This command sets the IGMP Group Membership Interval time on a VLAN, one
interface or all interfaces. The Group Membership Interval time is the amount of time
in seconds that a switch waits for a report from a particular group on a particular
interface before deleting the interface from the entry. This value must be greater than
the IGMPv3 Maximum Response time value. The range is 2 to 3600 seconds.

Default

260 seconds

Format

set igmp groupmembership-interval

<2-3600>

Modes

Interface Config
Global Config

Format

set igmp groupmembership-interval

<vlan_id> <2-3600>

Modes

VLAN Config

2.15.4.1

no set igmp groupmembership-interval

This command sets the IGMPv3 Group Membership Interval time to the default value.

Format

no set igmp groupmembership-interval

Modes

Interface Config
Global Config

Format

no set igmp groupmembership-interval <vlan_id>

Mode

VLAN Config

2.15.5

set igmp maxresponse

This command sets the IGMP Maximum Response time for the system, or on a
particular interface or VLAN. The Maximum Response time is the amount of time in
seconds that a switch will wait after sending a query on an interface because it did not
receive a report for a particular group in that interface. This value must be less than the
IGMP Query Interval time value. The range is 1 to 3599 seconds.

Advertising