Kontron AT8402 CLI - Manual (Page 197)

AT8402 Management Commands
Page 5 - 7 AT8402 CLI Reference Manual
Default enabled
Format
ip telnet server enable
Mode Privileged EXEC
5.3.1.1 no ip telnet server enable
Use this command to disable Telnet access to the system and to disable the Telnet
Server Admin Mode. This command closes the Telnet listening port and disconnects all
open Telnet sessions.
Format
no ip telnet server enable
Mode Privileged EXEC
5.3.2 telnet
This command establishes a new outbound Telnet connection to a remote host. The
host value must be a valid IP address. Valid values for port should be a valid decimal
integer in the range of 0 to 65535, where the default value is 23. If [debug] is used, the
current Telnet options enabled is displayed. The optional line parameter sets the
outbound Telnet operational mode as ‘linemode’, where by default, the operational
mode is ‘character mode’. The noecho option disables local echo.
Format
telnet <host> <port> [debug] [line] [noecho]
Modes Privileged EXEC
User EXEC
5.3.3 transport input telnet
This command regulates new Telnet sessions. If enabled, new Telnet sessions can be
established until there are no more sessions available. An established session remains
active until the session is ended or an abnormal network error ends the session.
NOTE: If the Telnet Server Admin Mode is disabled, Telnet sessions cannot
be established. Use the
ip telnet server enable
command to
enable Telnet Server Admin Mode.
Default enabled
Format
transport input telnet
Mode Line Config
5.3.3.1 no transport input telnet
Use this command to prevent new Telnet sessions from being established.
Format
no transport input telnet
Mode Line Config
5.3.4 transport output telnet
This command regulates new outbound Telnet connections. If enabled, new outbound
Telnet sessions can be established until the system reaches the maximum number of
simultaneous outbound Telnet sessions allowed. An established session remains active
until the session is ended or an abnormal network error ends it.