Kontron AT8402 CLI - Manual (Page 55)

AT8402 Switching Commands
Page 2 - 23 AT8402 CLI Reference Manual
2.3.17 protocol group
This command attaches a
<vlanid>
to the protocol-based VLAN identified by
<groupid>
. A group may only be associated with one VLAN at a time, however the
VLAN association can be changed.
The referenced VLAN should be created prior to the creation of the protocol-based
VLAN except when GVRP is expected to create the VLAN.
Default none
Format
protocol group
<groupid> <vlanid>
Mode VLAN Config
2.3.17.1 no protocol group
This command removes the
<vlanid>
from this protocol-based VLAN group that is
identified by this
<groupid>
.
Format no protocol group <groupid> <vlanid>
Mode VLAN Config
2.3.18 protocol vlan group
This command adds the physical interface to the protocol-based VLAN identified by
<groupid> . You can associate multiple interfaces with a group, but you can only
associate each interface and protocol combination with one group. If adding an
interface to a group causes any conflicts with protocols currently associated with the
group, this command fails and the interface(s) are not added to the group.
You should create the referenced VLAN before you create the protocol-based VLAN
except when you configure GVRP to create the VLAN.
Default none
Format
protocol vlan group
<groupid>
Mode Interface Config
2.3.18.1 no protocol vlan group
This command removes the interface from this protocol-based VLAN group that is
identified by this
<groupid>
.
Format no protocol vlan group <groupid>
Mode Interface Config
2.3.19 protocol vlan group all
This command adds all physical interfaces to the protocol-based VLAN identified by
<groupid> . You can associate multiple interfaces with a group, but you can only
associate each interface and protocol combination with one group. If adding an
interface to a group causes any conflicts with protocols currently associated with the
group, this command will fail and the interface(s) will not be added to the group.