Kontron AT8402 CLI - Manual (Page 213)

AT8402 Management Commands
Page 5 - 23 AT8402 CLI Reference Manual
Mode Privileged EXEC
Authentication Flag Can be enabled or disabled. The factory default is enabled. Indi-
cates whether authentication failure traps will be sent.
Link Up/Down Flag Can be enabled or disabled. The factory default is enabled. Indi-
cates whether link status traps will be sent.
Multiple Users Flag Can be enabled or disabled. The factory default is enabled. Indi-
cates whether a trap will be sent when the same user ID is logged into
the switch more than once at the same time (either through Telnet or
the serial port).
Spanning Tree Flag Can be enabled or disabled. The factory default is enabled. Indi-
cates whether spanning tree traps are sent.
ACL Traps May be enabled or disabled. The factory default is disabled. Indicates
whether ACL traps are sent.
DVMRP Traps Can be enabled or disabled. The factory default is disabled. Indicates
whether DVMRP traps are sent.
OSPF Traps Can be enabled or disabled. The factory default is disabled. Indicates
whether OSPF traps are sent.
PIM Traps Can be enabled or disabled. The factory default is disabled. Indicates
whether PIM traps are sent.
5.7 CLI Command Logging Command
This section describes the commands you use to configure CLI Command Logging.
5.7.1 logging cli-command
This command enables the CLI command logging feature, which enables the
FASTPATH software to log all CLI commands issued on the system.
Default
enabled
Format
logging cli-command
Mode Global Config
5.7.1.1 no logging cli-command
This command disables the CLI command Logging feature.
Format
no logging cli-command
Mode Global Config
5.8 RADIUS Commands
This section describes the commands you use to configure the switch to use a Remote
Authentication Dial-In User Service (RADIUS) server on your network for
authentication and accounting.