Kontron AT8402 CLI - Manual (Page 66)

Switching Commands AT8402
AT8402 CLI Reference Manual Page 2 - 34
2.8 GVRP Commands
This section describes the commands you use to configure and view GARP VLAN
Registration Protocol (GVRP) information. GVRP-enabled switches exchange VLAN
configuration information, which allows GVRP to provide dynamic VLAN creation on
trunk ports and automatic VLAN pruning.
NOTE: If GVRP is disabled, the system does not forward GVRP messages.
2.8.1 set gvrp adminmode
This command enables GVRP on the system.
Default disabled
Format
set gvrp adminmode
Mode Privileged EXEC
2.8.1.1 no set gvrp adminmode
This command disables GVRP.
Format
no set gvrp adminmode
Mode Privileged EXEC
2.8.2 set gvrp interfacemode
This command enables GVRP on a single port (Interface Config mode) or all ports
(Global Config mode).
Default disabled
Format
set gvrp interfacemode
Modes Interface Config
Global Config
2.8.2.1 no set gvrp interfacemode
This command disables GVRP on a single port (Interface Config mode) or all ports
(Global Config mode). If GVRP is disabled, Join Time, Leave Time and Leave All
Time have no effect.
Format no set gvrp interfacemode
Modes Interface Config
Global Config
2.8.3 show gvrp configuration
This command displays Generic Attributes Registration Protocol (GARP) information
for one or all interfaces.
Format
show gvrp configuration
{<slot/port> | all}
Modes Privileged EXEC
User EXEC