18 snmp trap link-status, 19 snmp trap link-status all, 20 show snmpcommunity – Kontron AT8402 CLI User Manual

Page 211: At8402 management commands

Advertising
background image

AT8402

Management Commands

Page 5 - 21

AT8402 CLI Reference Manual

Format

snmptrap mode

<name> <ipaddr>

Mode

Global Config

5.6.17.1

no snmptrap mode

This command deactivates an SNMP trap. Disabled trap receivers are unable to receive

traps.
Format

no snmptrap mode

<name> <ipaddr>

Mode

Global Config

5.6.18

snmp trap link-status

This command enables link status traps by interface.

NOTE: This command is valid only when the Link Up/Down Flag is enabled.

See “snmp-server enable traps linkmode” on page 5 - 19.

Format

snmp trap link-status

Mode

Interface Config

5.6.18.1

no snmp trap link-status

This command disables link status traps by interface.

NOTE: This command is valid only when the Link Up/Down Flag is enabled.

Format

no snmp trap link-status

Mode

Interface Config

5.6.19

snmp trap link-status all

This command enables link status traps for all interfaces.

NOTE: This command is valid only when the Link Up/Down Flag is enabled.

See “snmp-server enable traps linkmode” on page 5 - 19.

Format

snmp trap link-status all

Mode

Global Config

5.6.19.1

no snmp trap link-status all

This command disables link status traps for all interfaces.

NOTE: This command is valid only when the Link Up/Down Flag is enabled.

See “snmp-server enable traps linkmode” on page 5 - 19.

Format

no snmp trap link-status all

Mode

Global Config

5.6.20

show snmpcommunity

This command displays SNMP community information. Six communities are

supported. You can add, change, or delete communities. The switch does not have to be

reset for changes to take effect.

Advertising