6 diffserv show commands, 1 show class-map, 6 diffserv show commands - 16 – Kontron AT8402 CLI User Manual
Page 128: Show class-map - 16, Quality of service (qos) commands at8402
Quality of Service (QoS) Commands
AT8402
AT8402 CLI Reference Manual
Page 3 - 16
Format
service-policy in
<policymapname>
Modes
Global Config
Interface Config
NOTE: Each interface can have one policy attached.
3.5.1.1
no service-policy
This command detaches a policy from an interface in the inbound direction. The
<policyname>
parameter is the name of an existing DiffServ policy.
NOTE: This command causes a service to remove its reference to the policy.
This command effectively disables DiffServ on an interface in the
inbound direction. There is no separate interface administrative 'mode'
command for DiffServ.
Format
no service-policy in
<policymapname>
Modes
Global Config
Interface Config
3.6
DiffServ Show Commands
Use the DiffServ show commands to display configuration and status information for
classes, policies, and services. You can display DiffServ information in summary or
detailed formats. The status information is only shown when the DiffServ
administrative mode is enabled.
3.6.1
show class-map
This command displays all configuration information for the specified class. The
<class-name>
is the name of an existing DiffServ class.
Format
show class-map
<class-name>
Modes
Privileged EXEC
User EXEC
If the class-name is specified the following fields are displayed:
Class Name The name of this class.
Class Type
A class type of ‘all’ means every match criterion defined for the class
is evaluated simultaneously and must all be true to indicate a class
match.
Match Criteria The Match Criteria fields are only displayed if they have been config-
ured. Not all platforms support all match criteria values. They are dis-
played in the order entered by the user. The fields are evaluated in
accordance with the class type. The possible Match Criteria fields are:
Destination IP Address, Destination Layer 4 Port, Destination MAC
Address, Ethertype, Source MAC Address, VLAN, Class of Service,
Every, IP DSCP, IP Precedence, IP TOS, Protocol Keyword, Refer-
ence Class, Source IP Address, and Source Layer 4 Port.
Values
The values of the Match Criteria.