4 match class-map, 5 match dstip, 6 match dstl4port – Kontron AT8402 CLI User Manual
Page 121: Match class-map - 9, Match dstip - 9, Match dstl4port - 9, At8402 quality of service (qos) commands
AT8402
Quality of Service (QoS) Commands
Page 3 - 9
AT8402 CLI Reference Manual
Mode
Class-Map Config
3.3.4
match class-map
This command adds to the specified class definition the set of match conditions defined
for another class. The
<refclassname>
is the name of an existing DiffServ class whose
match conditions are being referenced by the specified class definition. There is no
default value.
Format
match class-map
<refclassname>
Mode
Class-Map Config
NOTE:
•
The parameters
<refclassname>
and
<class-map-name>
can not be the same.
•
Only one other class may be referenced by a class.
•
Any attempts to delete the
<refclassname>
class while the class is still referenced
by any
<class-map-name>
fails.
•
The combined match criteria of
<class-map-name>
and
<refclassname>
must be
an allowed combination based on the class type.
•
Any subsequent changes to the
<refclassname>
class match criteria must main-
tain this validity, or the change attempt fails.
•
The total number of class rules formed by the complete reference class chain
(including both predecessor and successor classes) must not exceed a platform-
specific maximum. In some cases, each removal of a refclass rule reduces the max-
imum number of available rules in the class definition by one.
3.3.4.1
no match class-map
This command removes from the specified class definition the set of match conditions
defined for another class. The
<refclassname>
is the name of an existing DiffServ
class whose match conditions are being referenced by the specified class definition.
Format
no match class-map
<refclassname>
Mode
Class-Map Config
3.3.5
match dstip
This command adds to the specified class definition a match condition based on the
destination IP address of a packet. The
<ipaddr>
parameter specifies an IP address and
<ipmask>
specifies a subnet mask and must consist of a contiguous set of leading 1
bits.
Default
none
Format
match dstip
<ipaddr> <ipmask>
Mode
Class-Map Config
3.3.6
match dstl4port
This command adds to the specified class definition a match condition based on the
destination layer 4 port of a packet using a single keyword or numeric notation. To
specify the match condition as a single keyword, the value for
<portkey>
is one of the
supported port name keywords. The currently supported
<portkey>
values are:
domain,