2 storm-control broadcast level, 3 storm-control broadcast all, 4 storm-control broadcast all level – Kontron AT8402 CLI User Manual

Page 79: At8402 switching commands

Advertising
background image

AT8402

Switching Commands

Page 2 - 47

AT8402 CLI Reference Manual

2.11.2

storm-control broadcast level

Use this command to configure the broadcast storm recovery threshold for an interface.
When you use this command, broadcast storm recovery mode is enabled on the
interface and broadcast storm recovery is active. If the rate of L2 broadcast traffic
ingressing on an interface increases beyond the configured threshold, the traffic is
dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold.

Default

5

Format

storm-control broadcast level

<0-100>

Mode

Interface Config

2.11.2.1

no storm-control broadcast level

This command sets the broadcast storm recovery threshold to the default value for an
interface and disables broadcast storm recovery.

Format

no storm-control broadcast level

Mode

Interface Config

2.11.3

storm-control broadcast all

This command enables broadcast storm recovery mode for all interfaces. If the mode is
enabled, broadcast storm recovery is active, and if the rate of L2 broadcast traffic
ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of broadcast traffic will be limited to the configured
threshold.

Default

disabled

Format

storm-control broadcast all

Mode

Global Config

2.11.3.1

no storm-control broadcast all

This command disables broadcast storm recovery mode for all interfaces.

Format

no storm-control broadcast all

Mode

Global Config

2.11.4

storm-control broadcast all level

This command configures the broadcast storm recovery threshold for all interfaces. If
the mode is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast
traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of broadcast traffic will be limited to the
configured threshold.This command also enables broadcast storm recovery mode for
all interfaces.

Default

5

Format

storm-control broadcast all level

<0-100>

Mode

Global Config

Advertising