Kontron AT8402 CLI - Manual (Page 202)

Management Commands AT8402
AT8402 CLI Reference Manual Page 5 - 12
5.4.5 sshcon timeout
This command sets the SSH connection session timeout value, in minutes. A session is
active as long as the session has been idle for the value set. The time is a decimal value
from 1 to 160.
Changing the timeout value for active sessions does not become effective until the
session is re accessed. Also, any keystroke activates the new timeout duration.
Default
5
Format
sshcon timeout
<1-160>
Mode Privileged EXEC
5.4.5.1 no sshcon timeout
This command sets the SSH connection session timeout value, in minutes, to the
default.
Changing the timeout value for active sessions does not become effective until the
session is re accessed. Also, any keystroke activates the new timeout duration.
Format
no sshcon timeout
Mode Privileged EXEC
5.4.6 show ip ssh
This command displays the ssh settings.
Format
show ip ssh
Mode Privileged EXEC
Administrative Mode This field indicates whether the administrative mode of SSH is
enabled or disabled.
Protocol Level The protocol level may have the values of version 1, version 2 or both
versions 1 and version 2.
Connections This field specifies the current SSH connections.
5.5 User Account Commands
This section describes the commands you use to add, manage, and delete system users.
FASTPATH software has two default users: admin and guest. The admin user can view
and configure system settings, and the guest user can view settings.
NOTE: You cannot delete the admin user. There is only one user allowed with
read/write privileges. You can configure up to five read-only users on
the system.
5.5.1 users name
This command adds a new user account, if space permits. The account <username>
can be up to eight characters in length. You can use alphanumeric characters as well as
the dash (‘-’) and underscore (‘_’). You can define up to six user names.