KEYENCE DL-DN1 - Manual (Page 43)

3-2 I/O Communication
3-15 - DeviceNet Compatible Network Unit DL-DN1 User's Manual -
3
Comm
un
ica
ti
ng wit
h th
e
IB
Ser
ies
IN area
n: The first device number assigned to the DL-DN1
The device assignments are the same for all 5-output modes including extended
modes.
The following describes how the DeviceNet master unit communicates with the DL-
DN1 (slave unit) using I/O communication (polling).
"Reading an output from a sensor amplifier" (page 3-15)
"Entering an external input into a sensor amplifier" (page 3-16)
"Reading comparator values (P.V. values) from sensor amplifiers" (page 3-17)
"Changing the BANK number of sensor amplifiers" (page 3-18)
"Rewriting a setting value of a sensor amplifier" (page 3-19)
For the communication methods using explicit messaging, see "Explicit
Messaging" (page 3-20).
Reading an output from a sensor amplifier
Available outputs: HIGH, LOW, GO, and check output
Device assignments: "Output" (page 3-9)
This example reads the HIGH output from the sensor amplifier of ID01.
It assumes that the operating mode assigned to the device is 3-output mode.
(1) The output from the sensor amplifier is brought into the IN area by I/O communica-
tion.
Device
(DEC)
Name
Bit 7 Bit 6 ... Bit 1 Bit0
Bit 15 Bit 14 ... Bit 9 Bit 8
n㪂㪈㪈 Setting-value rewrite error
ID08 ID07 ... ID02 ID01
Reserved ID15 ... ID10 ID09
n㪂㪈㪉
HIGH setting value (BANK 0)
rewrite complete
ID08 ID07 ... ID02 ID01
Reserved ID15 ... ID10 ID09
n㪂㪈㪊
LOW setting value (BANK 0)
rewrite complete
ID08 ID07 ... ID02 ID01
Reserved ID15 ... ID10 ID09
n㪂㪈㪋
Shift target value (BANK 0)
rewrite complete
ID08 ID07 ... ID02 ID01
Reserved ID15 ... ID10 ID09
n㪂㪈㪌
HIGH setting value (BANK 1)
rewrite complete
ID08 ID07 ... ID02 ID01
Reserved ID15 ... ID10 ID09
n㪂㪈㪍
LOW setting value (BANK 1)
rewrite complete
ID08 ID07 ... ID02 ID01
Reserved ID15 ... ID10 ID09
Communication Methods
PLC
Output of sensor amplifier
IN area [n+1]Bit0
Sensor amplifier (1)
Output
HIGH output of ID 01
1
0
ON
OFF