KEYENCE DL-CL1 - Manual (Page 32)

3-4
3
Co
mm
u
ni
c
a
ting
w
ith t
he FD
-M
H
s
er
ie
s
- CC-Link Compatible Network Unit DL-CL1 User’s Manual (FD-MH) -
3-2
Device Maps
The device maps vary as described in "Selecting an Operating Mode of the DL-
CL1" (page 3-3). Select an operating mode suited for the functions of the sensor
amplifiers to be used, before accessing each device.
The following device maps are used for when the operating mode is small-memory
mode 1, small-memory mode 2, or monitor mode 1.
In cases of monitor mode 2, full mode 1, and full mode 2, see "Device Maps for
Monitor Mode 2, Full Mode 1, and Full Mode 2" (page 3-10).
Remote Input RX (DL-CL1 -> Master Station)
Device Maps for Small-Memory Mode 1, Small-Memory Mode 2, and Monitor Mode 1
Operating
mode
Device no.
(HEX)
Name
Communication
method
Description Reading range
S
mall-memor
y mode
1
S
mall-memor
y mode
2
Monitor mode
1
RX[n] + 00
to 09 Output-1 ID 01
to ID10
*1
Sends the output-1 state (ON/OFF) of the
sensor amplifi er.
The output-1 of each sensor amplifi er (ID 01
to ID 10) corresponds to each RX.
0: OFF
1: ON
RX[n] + 0F Error state -
The DL-CL1 is not communicating properly
with the sensor amplifi er, or an error exists
with the sensor amplifi er.
If an error exists, the error code is stored in
error code (RWr[n] + 00).
0:No Error
1:Error
RX[n] + 10
to 19 Output-2 ID 01
to ID10
*1
Sends the output-2 state (ON/OFF) of the
sensor amplifi er.
The output-2 of each sensor amplifi er (ID 01
to ID 10) corresponds to each RX.
0: OFF
1: ON
RX[n] + 1F (Not used) - -
RX[n] + 20
to 29 Output-3 ID 01
to ID10
*1
Sends the output-3 state (ON/OFF) of the
sensor amplifi er.
The output-3 of each sensor amplifi er (ID 01
to ID 10) corresponds to each RX.
0: OFF
1: ON
RX[n] + 2F System reserved - Unusable
RX[n] + 30
to 39
(Not used) - -
RX[n] + 3F System reserved - Unusable
RX[n] + 40
to 49
(Not used) - -
RX[n] + 4F System reserved - Unusable
RX[n] + 50 Sensor ready *3
Used when communicating under handshake
control program.
This is output when command execution is
ready.
0: In preparation
1: Ready
RX[n] + 51
Command
complete
*3
Used when communicating under handshake
control program.
This is output when command execution is
complete.
0->1: Execution
complete
RX[n] + 52 Command error *3
Used when communicating under handshake
control program.
This is output when an error occurs during
command execution.
0:No Error
1:Error