2 installing the bl-u1, Power supply bl-u1 – KEYENCE BL-180 User Manual
Page 96
Power Supply BL-U1
90
2.2
Installing the BL-U1
There are two methods for installing the BL-U1:
When installing the BL-U1 directly
Pull out the four screw slots on the rear panel and screw them to the base.
When installing the BL-U1 to the DIN rail
1. Hook the BL-U1 to the DIN rail groove from its top. Push the BL-U1 bottom
against the DIN rail until you hear a click.
2. Check that the DIN rail mounting notch is shaped like notch A below. If not,
push the BL-U1 further.
3. To remove the BL-U1 from the DIN rail, pull out the notch until its shape turns
from Fig. B to Fig. A. Then, disengage the BL-U1 from the DIN rail.
4. When you want to re-install the BL-U1 to the DIN rail, return the notch from
that of Fig. A to Fig. B.
4-ø5
150
98
OK
Insufficient
Fig. A
Fig. B