Reznor R6GN Option - Installation - High Static Blower Drive - Light Commercial - Manual (Page 25)

25
Q6SP-090* & Q5SN-090* HSD kits
920394 (208-230V, 3Ø, 60 Hz)
920608 (460V, 3Ø, 60 Hz)
Downfl ow Performance Chart ‡ Indicates Factory Sheave Setting for Pre-confi gured Units
External
Unit Static
(in-Wg)
Operating @
230 or 460
Volts
Adjustable Motor Sheave Setting
Fully
Closed
1/2 Turn
Open
1 Turn
Open
1.5 Turns
Open ‡
2.0 Turns
Open
2.5 Turns
Open
3.0 Turns
Open
3.5 Turns
Open
4.0 Turns
Open
4.5 Turns
Open
5.0 Turns
Open
5.5 Turns
Open
6.0 Turns
Open
0.9
CFM
RPM
kW
1.0
CFM
RPM
kW
1.1
CFM 3725 3273 2820
RPM 937 906 875
kW 2.03 1.80 1.56
1.2
CFM 3490
RPM 938
kW 2.18
1.3
CFM 3720 3370 3020
RPM 986 965 943
kW 2.42 2.22 2.01
1.4
CFM 3480 3010 2540
RPM 988 968 947
kW 2.24 2.04 1.84
1.5
CFM 3775 3393 3010
RPM 1032 1012 992
kW 2.36 2.21 2.05
1.6
CFM 3525 3033 2540
RPM 1035 1016 996
kW 2.23 2.06 1.89
1.7
CFM 3750 3400 3050
RPM 1074 1057 1040
kW 2.48 2.27 2.05
1.8
CFM 3900 3713 3525 3050 2575
RPM 1105 1092 1079 1062 1044
kW 2.95 2.69 2.43 2.16 1.88
1.9
CFM 3700 3375 3050
RPM 1109 1097 1084
kW 2.74 2.47 2.20
2.0
CFM 3100
RPM 1117
kW 2.33
Values includes losses for: Unit Casing, 2” Disposable Filters & Dry Evaporator Coil
Values shown refl ect operation at 230V or 460V. For operation at 208V, deduct 0.025 from unit static.
Deduct 250 Cfm for electric heater kits
3862
Indicates a recommended unit operational point 1159
3.03
3493
Indicates an allowable setting that is not recommended for unit operation †
† These operational points should be carefully examined by the installer for proper unit setup and heater operation if used.
1017
2.07
Indicates a setting that is not permitted for unit operation
Table 21. Blower Performance for Q6SP-090* & Q5SN-090* Units
(7.5 Ton Downfl ow Models Only)