Reznor R6GN Option - Installation - High Static Blower Drive - Light Commercial - Manual (Page 29)

29
R6GP-090*-200C HSD kits:
920559 (208-230V, 3Ø, 60 Hz)
920558 (460V, 3Ø, 60 Hz)
Downfl ow Performance Chart ‡ Indicates Factory Sheave Setting for Pre-confi gured Units
External
Unit Static
(in-Wg)
Operating @
230 or 460
Volts
Adjustable Motor Sheave Setting
Fully
Closed
1/2 Turn
Open
1 Turn
Open
1.5 Turns
Open
2.0 Turns
Open
2.5 Turns
Open
3.0 Turns
Open ‡
3.5 Turns
Open
4.0 Turns
Open
4.5 Turns
Open
5.0 Turns
Open
5.5 Turns
Open
6.0 Turns
Open
1.2
CFM 3417 3226 3035
RPM 1232 1203 1173
kW 2.32 2.10 1.88
1.3
CFM 3258 3055 2852
RPM 1235 1205 1175
kW 2.15 1.96 1.78
1.4
CFM 3448 3267 3085 2856 2626
RPM 1292 1265 1237 1208 1178
kW 2.47 2.24 2.01 1.82 1.64
1.5
CFM 3300 3099 2898 2677
RPM 1295 1268 1240 1211
kW 2.33 2.10 1.86 1.66
1.6
CFM 3164 2932 2705
RPM 1299 1271 1243
kW 2.24 1.96 1.69
1.7
CFM 3392 3178 2963 2756
RPM 1356 1329 1302 1274
kW 2.63 2.34 2.06 1.80
1.8
CFM 3422 3214 2997
RPM 1384 1358 1332
kW 2.75 2.53 2.26
1.9
CFM 3437 3251 3016
RPM 1414 1389 1364
kW 2.88 2.58 2.42
2.0
CFM 3306 3033
RPM 1419 1394
kW 2.76 2.45
Values include losses for: Unit Casing, 2” Disposable Filters, Dry Evaporator Coil & Installed Heat Exchanger
Values shown refl ect operation at 230V or 460V. For operation at 208V, deduct 0.025 from unit static.
3862
Indicates a recommended unit operational point 1159
3.03
3493
Indicates an allowable setting that is not recommended for unit operation †
† These operational points should be carefully examined by the installer for proper unit setup and heater operation if used.
1017
2.07
Indicates a setting that is not permitted for unit operation
Table 25. Blower Performance for R6GP-090*-200C Units
(7.5 Ton Downfl ow Models Only)