Reznor R6GN Option - Installation - High Static Blower Drive - Light Commercial - Manual (Page 31)

31
R6GP-120*-235C HSD kits:
920395 (208-230V, 3Ø, 60 Hz)
920396 (460V, 3Ø, 60 Hz)
Downfl ow Performance Chart ‡ Indicates Factory Sheave Setting for Pre-confi gured Units
External
Unit Static
(in-Wg)
Operating @
230 or 460
Volts
Adjustable Motor Sheave Setting
Fully
Closed
1/2 Turn
Open
1 Turn
Open
1.5 Turns
Open
2.0 Turns
Open
2.5 Turns
Open
3.0 Turns
Open ‡
3.5 Turns
Open
4.0 Turns
Open
4.5 Turns
Open
5.0 Turns
Open
5.5 Turns
Open
6.0 Turns
Open
0.9
CFM
RPM
kW
1.0
CFM
RPM
kW
1.1
CFM 4672
RPM 975
kW 2.65
1.2
CFM 4673 4466
RPM 998 979
kW 2.75 2.50
1.3
CFM 4630 4429 4227
RPM 1018 1000 982
kW 2.90 2.65 2.40
1.4
CFM 4611 4394 4191 3988
RPM 1039 1020 1003 985
kW 2.95 2.70 2.50 2.30
1.5
CFM 4613 4391 4168 3714 3260
RPM 1058 1041 1023 1006 989
kW 3.10 2.85 2.60 2.38 2.15
1.6
CFM 4379 4181 3982 3257
RPM 1061 1046 1031 1012
kW 2.90 2.70 2.50 2.25
1.7
CFM 4480 4233 3976 3718
RPM 1087 1070 1053 1036
kW 3.10 2.80 2.55 2.30
1.8
CFM 4244 3996 3683 3370
RPM 1089 1072 1056 1039
kW 2.90 2.60 2.40 2.20
1.9
CFM 4278 4011 3744
RPM 1111 1093 1075
kW 3.10 2.80 2.50
2.0
CFM 4252 4016 3455
RPM 1130 1115 1097
kW 3.10 2.90 2.50
Values include losses for: Unit Casing, 2” Disposable Filters, Dry Evaporator Coil & Installed Heat Exchanger
Values shown refl ect operation at 230V or 460V. For operation at 208V, deduct 0.025 from unit static.
3862
Indicates a recommended unit operational point 1159
3.03
3493
Indicates an allowable setting that is not recommended for unit operation †
† These operational points should be carefully examined by the installer for proper unit setup and heater operation if used.
1017
2.07
Indicates a setting that is not permitted for unit operation
Table 27. Blower Performance for R6GP-120*-235C Units
(10 Ton Downfl ow Models Only)