SINGER 1200 Athena User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Aítachins Darning and Embroidery Foot

Attaching Cbalnstitch Fittings

SieamLGMsde,,

Darning and Embroidery Foot

1. Raise needle and take-up lever to highest

position by turning hand vsrheel toward

you.

2.

Raise foot.

3. Loosen presser foot screw and remove

presser foot shank.

4. Guide darfiing and embroidery foot into

position from back of machine. Make sure
lifting finger (B) is above needle clamp.

5. Tighten presser foot screw with coin.

CMAmmuB

i

^

eeole

plates

Mote: Remove bobbin if it contains thread in
order to prevent thread being caught when
piate is replaced.

1. Raise needle and take-up lever to highest

position by turning

the

hand wheel

toward

you.

2. Raise presser foot.

3. Open slide plate. Press down on front edge

of plate and lift up and out.

4. Position new plate over pins and release.

Plate is drawn into position by magnets.
See special Instructions below for attach­
ing chainstitch plate.

5. Close slide plate.

Chainstitch Plate and Insert

1. Raise needle and take-up lever to highest

position and raise presser foot.

2. Open slide plate.

3. Move bobbin latch to left and remove bob­

bin and needle plate from machine.

4. Place bobbin-case Insert in bobbin case as

shown, with finger of insert positioned

under the feed.

5.

Position chainstitch plate over holding

pins, making certain that the

post of the

bobbin-case insert finger enters the hole in
the plate.

6. Close slide plate.

ATTACHIMC THE SEAÜ GUIDE

Place screw in hole to the right of the slide
piate; line up straight edge of guide with the
needle plate guideline for desired seam width,

and tighten screw.

Advertising