SINGER 1200 Athena - Manual (Page 9)

choosing and changing
accessories
CHANGIMG PRESSEH FEET
Snap-on Presser Feet
Most of the presser feet furnished with your
machine snap on and off a common shank,
e Raise needle and take-up lever to highest
position by turning the hand wheel toward
you.
» Raise presser foot.
1. Press toe of presser foot upward (as far as
it will go) and then snap down to remove.
2. Center the new presser foot under the
shank and lower the presser-foot lifter so
that the shank fits over the presser-foot
pin.
3. Press presser-foot screw down firmly until
foot snaps into place.
To remove and replace the shank of snap-on
presser feet, follow instructions below for
one-piece presser feet.
One-piece Presser Feet
CButton Foot and Zipper Foot)
• Raise needle and take-up lever to highest
position by turning the hand wheel toward
you.
« Raise presser foot.
e Loosen presser foot screv»^ (A) and remove
the foot, guiding it to the right.
Note: When changing one-piece presser
feet, you should insert the edge of a coin in
the slot of the presser foot screw to tighten
presser foot securely.
To Replace One-piece Feet
® Hook one-piece foot around the presser bar
and tighten presser-foot screw.
Changing Snap-on Presser Feet
Changing One-piece Presser Foot