SINGER 1200 Athena User Manual
Page 85
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHAMGIMG THE LIGHT BULB
Caution: Before changing Ught bulb make sure
you
have
disconnected
power-line
plug
from
electrical outlet.
Removing Bulb. With thumb of right hand,
push in and down on tab of light lens and
lower the light bracket.
Do not attempt to
unscrew the bulb.
Press it up into the socket
and at the same time turn bulb over in direc
tion shown to unlock the bulb pin.
Caution:
Be sure to use a 15 watt bulb
only.
Replacing Bulb. Press new bulb into socket,
with bulb pin entering slot of socket, and turn
it over in direction shown to lock bulb in posi
tion. Push entire asserribly up until it snaps in
position.
Unlocks
Locks
The electronic system of your miachine is pro
tected by a circuit breaker. If the sewing light
goes on and the needle bar moves up and
down, but you cannot select a pattern, you
must push the red circuit breaker button (A)
to reaotivate the machine. If your machine is a
portable model, carefully lift or tilt it to gain
access to the button. Push button in. If your
machine is secured to a cabinet, reach under
front of cabinet and locate the special hole
which gives you access to the button. Push
button. Certain cabinet models may not have
an access hole. In such instances, release
the machine from the cabinet, tilt machine,
and push button. Re-secure machine to
cabinet. Re-select desired pattern.
Note: If button continues to disengage, con
tact your Singer representative or Approved
Dealer.