Getting ready to sew, Choosing and changing accessories, Changing presser feet – SINGER 1288 User Manual
Page 11: Z getting ready to sew
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Getting Ready to Sew
Choosing and Changing
Accessories
CAUTION:
Disconnect the power tine plug from the
socket outlet when changing needles, feet, or needle
plates, or when leaving the machine unattended. This
eliminates the possibility of starting the machine by
accidentally pressing the speed controller.
Changing Presser Feet
• Raise needle to highest position by turning the hand
wheel toward you.
• Raise presser foot.
1. Press toe of presser foot upward as far as it will go
until it snaps free.
2. Centre the new presser foot under the shank A.
Lower the presser foot lifter so that the shank fits
over the presser foot pin.
3. Press presser foot screw down firmly until foot
snaps into place.
10