Raising the bobbin thread – SINGER 1288 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Raising the Bobbin Thread
Hold needle thread lightly with left hand and turn hand
wheel slowly toward you until the needle enters plate.
Continue turning hand wheel and holding needle
thread until needle rises. Tighten your hold on the
needle thread and bring up bobbin thread in a loop.
Open the loop with your fingers. Draw approximately
10 cm (4 inches) of both threads under the presser foot
and place them diagonally to left. Close slide plate.
26
Advertising