Maytag Atlantis User Manual
Page 118
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Section 5. Front Removal
Procedure
Lift Top Assembly by releasing spring clips between
top and front panel. Use a plastic putty knife to
disengage clip. Lift top and remove top screws through
the back of the Front Panel. There are two spring clips
a screws one each side.
Section 6. Pump Assembly
Atlantis washers use a new pump assembly which will
be totally replaced should it require repair. A pump kit
will be available containing the entire pump assembly.
Section 7. Tub Seal and
Bearing
The Allantis III Seal and Bearing are unique and are
matched to the duel drive high torque transmission,
used on this washer. When replacing the seal and
bearing, order parts specific to the Atlantis III washer.
The seal and bearing used on older models will not
fuction properly. The seal kit will also be supplied with
the replacement transmission assembly if it is
necessary to install a new one.
16009485-03 Rev. 0
©2002 Maytag Appliances Company