Maytag Atlantis - Manual (Page 30)

VERTICAL SWITCHES (Push Button)
REMOVAL
1. Depress the tab at the top of the switch
with a screwdriver to disengage the tab
from the console. Pivot the switch away
from the console to remove (Figure 4-5).
REPLACEMENT
1. Align the rib on the bottom of the switch
with the slot in the console. Pivot the
switch up into the console until the tab en­
gages the console securely. Check that the
locating tabs on either side of the switch's
lower alignment rib are in position to prop­
erly center and lock the switch into the
lower part of the switch opening.
3. Disengage the console assembly from the
top cover and roll forward (See Console
Removal).
4. Remove timer mounting screws under the
timer knob.
TIMER REMOVAL - All MAV Models Except
MAV8500
1. Disconnect power to the unit.
2. Carefully lift the timer knob cap from the
timer knob and pry the clip retainer from
the timer shaft. Lift the dial and knob off
the timer shaft by pulling away from the
face of the control console (Figure 4-6).
5. Lift the timer away from the console.
REPLACEMENT
1. Reverse steps 1 through 5.
TIMER REMOVAL - MAV8500 Models
1. Disconnect power to the unit.
2. Remove the knob cap.
3. Gently pry the locking pin up and lift the
timer knob off the dial skirt.
4. Lift the dial skirt off the timer shaft
(Figure 4-7).
16009485-01 Section 4. Cabinet Assembly Components 4_2
©1999 Maytag Appliances Sales Company