Maytag Atlantis - Manual (Page 45)

Figure 5-7
REMOVAL
1. Disconnect power to the unit.
2. Remove the inner tub.
3. Remove the front panel.
4. Disconnect the pump inlet hose from the
outer tub outlet.
5. Remove the screws located on each side
of the tub brace bolts which secure the
tub to the tub support.
6. Remove the mounting screws on the in­
side of the tub which mount the tub to the
bearing and seal housing.
7. Disconnect air dome hose.
8. PROTECT THE AIR BELL NIPPLE and lift
the tub from the cabinet.
NOTE: The air bell nipple is fragile, handle
carefully.
NOTE: When reinstalling the tub assembly,
be sure to:
• Protect the air bell nipple.
• Clean all connecting surfaces to ensure
proper sealing.
• Position the gasket and seal on the bear­
ing and seal housing.
• Tighten all screws securely.
PUMP ASSEMBLY
Pump
Housing
Impeller
Seal
Assembly
Plate & Pulley
Assembly
Figure 5-8
16009485-01 Section 5. Water Related Components 5-5
©1999 Maytag Appliances Sales Company