Maytag Atlantis - Manual (Page 33)

REMOVAL
1. Lift the washer lid.
2. Locate the left hinge and lift the locking
tab in the center of the hinge from the lo­
cating hole in rear edge of the lid
(Figure 4-12).
3. Gently pry the hinge toward the center of
the lid. This will draw the pin of the hinge
out of the bushing in the top cover
(Figure 4-12).
4. With the left hinge removed, grasp the lid
and pull the lid away from the right hand
bushing in the top cover.
REPLACEMENT
1. Reverse steps 1 through 4.
30 DAY DETERGENT DISPENSER
(Optional Accessory)
The Dosing Lid Assembly consists of the de­
tergent reservoir, dispenser valve assembly,
cap and twist locks.
The reservoir stores liquid detergent and will
dispense the detergent directly into the spin
basket when the actuator is manually de­
pressed. The detergent reservoir is secured
into the lid by four twist locks.
Removal of Reservoir
1. Turn each of the twist locks on the face of
the detergent reservoir 1/4 turn counter­
clockwise (Figure 4-13).
2. Pull the bottom of the reservoir away from
the lid and unhook the top of the reservoir
from under the lip of the lid.
Removal of Valve Assembly
1. Locate the locking clip below the dispens­
ing button (Figure 4-14).
2. Depress the dispensing button while slid­
ing the retaining clip down. This will re­
lease the plunger and dispensing button
and allow removal.
16009485-01 Section 4. Cabinet Assembly Components
4-5
©1999 Maytag Appliances Sales Company