Maytag Atlantis - Manual (Page 49)

Slide the metal part of the bracket out of the
slots in the plastic part of the bracket.
(Figure 5-10)
Figure 5-10
Installation of the water valve is the reverse
of the above procedure.
Stainless Steel
Spinner Assembly
The stainless steel spinner is composed of a
crimped stainless steel basket and a
polypropylene spinner top. There is a lower
insulating ring attached to the bottom of the
spinner and an upper insulating ring that fits
over the inner spinner bottom. These
insulating rings provide stability to the lower
spinner area. When replacing a spinner it is
recommended that the insulating rings be
replaced with the spinner assembly.
Removal:
1. Disconnect the power to the unit.
2. Raise the top assembly and lean it back.
3. Remove the tub top.
4. Remove the agitator
5. Remove the mounting screws.
6. Remove the upper insulating ring.
(Figure 5-11)
8 .
Figure 5-11
Lift the spinner up over the center post
and out of the cabinet
Depress the six (6) tabs (Figure 5-12) that
hold the spinner top to the spinner and
remove the spinner top.
Depress the four (4) tabs that hold the
lower insulating ring to the bottom of the
spinner and remove. (Figure 5-12) These
four (4) tabs are not necessary for correct
machine operation. These tabs are used
to assist in the manufacturing process. If
one or more break during removal, the
part is still functional. (See Figures 5-13
thru 5-14)
16010280
(16009485-02) SECTION 5. Water - Related Components
©2000 Maytag Appliances Sales Company
5-9