Maytag Atlantis - Manual (Page 38)

6. Disconnect lower wiring from the cabinet
rear (water mixing valve, power cord, etc.)
and remove pressure switch hose from tub
air bell.
7. Remove the screws attaching the cabinet
to the base.
8. Remove lower screws on cross braces.
9. Push the front of the cabinet slightly back
and carefully push or pull it off the rear of
the base assembly.
11. Remove motor mounting screws, ground
wire and wiring clips from base. Lift the
motor and plate assembly from the base.
12. Remove the suspension springs (See
SPRING REMOVAL, Page 6-2 thru 6-3).
13. Remove the stabilizer assembly from
the base assembly, as detailed later in
this section.
14. Transfer the remaining hardware from
the defective base to the replacement.
10. Disconnect the pump hose from the tub
outlet and remove the pump assembly and
hose from the base.
15. Installation is a reversal of the above
procedure.
16009485-01 Section 4. Cabinet Assembly Components 4-10
©1999 Maytag Appliances Sales Company