Maytag Atlantis - Manual (Page 12)

7. If the standpipe is less than 36" high, pull
the drain hose up vertically and snap the
hose into the retaining clip positioned on
the upper, rear cabinet wall (Figure 1-5).
8. Install gooseneck end of drain hose into
drain standpipe. Be sure the connection
is not airtight between the drain hose and
the standpipe. Standpipe must be at least
36" high. If the hose is twisted after it has
been placed into the standpipe, adjust the
end of the hose to remove the twist. To
remove the twist, turn the short end of
the hose while holding the base of the
hose stationary (Figure 1-6).
9. The drain hose should fit loosely in the
standpipe to prevent siphoning. (An anti­
siphon valve and associated parts are
available from your dealer, part number
12001586.)
NOTE: Be sure the drain hose is not
twisted or kinked.
LAUNDRY
TUB
STANDPIPE
SERVICE
UNIT
16009485-01
©1999 Maytag Appliances Sales Company
SL297TIF
Figure 1-7
Section 1. General Information 1-4