Maytag Atlantis - Manual (Page 35)

2. Position the cap of the detergent bottle be­
ing used under the spout of the dispenser.
3. Press and hold the button and dispense liq­
uid into the cup until the desired amount
has dispensed.
4. Slide the plastic indicator down the sight
window until even with the detergent
shown.
5. The next time the lid is lowered and raised,
the sight window will fill with liquid deter­
gent. By depressing the button until the
level in the sight window is even with the
indicator, will provide uniform dispensing
of detergent brand being used.
NOTE: Empty dispenser completely before
refilling. Do not mix different detergents.
Figure 4-17
2. Remove the dispenser valve assembly and
rinse with warm water fSee Removal of
Valve Assembly Page 4-6).
3. Fill the dispenser with hot or warm water
and gently tilt the dispenser forward and
back to flush the water around inside the
dispenser.
4. Turn the dispenser vertically so the fill cap
is facing up and remove the cap. Pour the
contents out and repeat the process until
dispenser is flushed. NOTE: Water will
flow out of the dispenser valve area.
5. Reinstall the dispensing valve assembly
into the reservoir. While depressing the
button, replace the clip onto the valve
assembly.
6. Reinstall the reservoir into the lid and se­
cure the twist locks.
7. Close and open the lid.
8. Press the "PUSH" button (plunger) to re­
lease any remaining water/detergent. Re­
peat steps 7 & 8 until no more water can
be drained from the dispenser. It is nor­
mal for a small amount of water to remain
in the dispenser after cleaning.
9. Refill the dispenser with liquid detergent.
The reservoir will hold 100 fluid ounces at
one time.
FRONT PANEL
CLEANING THE DISPENSER
Mixing different liquid detergents in the res­
ervoir can cause the detergent to clump and
clog the dispenser outlet. In which case, clean­
ing out the reservoir is necessary.
1. Remove the dispenser from the lid (See
Removal of Reservoir Page 4-6).
The front panel is attached to the cabinet side
flanges via screws at the top and secured at
the bottom with base mounting clips. Locat­
ing tabs on the front panel flanges position
the top cover for assembly (Figure 4-18).
The front panel provides mounting for the lo­
cating tabs and top clips. A plastic support
brace is wedged in the center of the panel for
support.
16009485-01 Section 4. Cabinet Assembly Components 4-7
©1999 Maytag Appliances Sales Company