Maytag Atlantis - Manual (Page 39)

STABILIZER ASSEMBLY
The stabilizer assembly consists of the
stabilizer bar assembly, two (2) stabilizer
brackets, two (2) self stabilizing feet, and
two (2) foot pins. It is mounted on the top
rear of the base assembly.
The stabilizer assembly allows the base
assembly to rest solidly and firmly against
the floor, even if the floor is unlevel. The
solidity of the base to the floor keeps the
washer from rocking back and forth or
“walking" during
operation.
As the name implies, the stabilizer only
stabilizes the unit; it does not level it. Any
leveling that is required must be done
with the front adjusting (leveling) legs.
In rare cases where the floor is so uneven
that it is beyond the stabilizing limit of the
assembly (+ or - 5/8"), It may be neces­
sary to remove the stabilizer assembly
and install two (2) rear adjustable feet.
Two (2) threaded holes have been pro­
vided in the rear corners of the base for
this situation. A kit, part number
12001577 is available.
REMOVAL
1. Disconnect power to the unit.
2. Remove the access panel from the
cabinet rear.
3. Tip or lay washer down, either forward
or on the side. Remove the screws
from the underside of the base that
attaches the stabilizer assembly to the
rear of the base (Figure 4-21).
4. Remove the stabilizer assembly
through the rear access panel.
5. To disassemble the stabilizer assembly
after removal, drive the two (2) foot
pins out of the feet and brackets.
NOTE: in order for the stabilizer assem­
bly to operate properly, a thin coating of
grease must be applied over the entire
length of the four (4) pin guides as well
as the foot holes in the bracket (Figure 4-
11 ).
16010280
( 16009485 - 02 )
SECTION 4. Cabinet Assembly Components
©2000 Maytag Appliances Sales Company
4-11