Maytag Atlantis - Manual (Page 69)

TRANSMISSION REMOVAL
The transmission assembly can be removed
from the washer cabinet after removing the
drive belt, spin basket, outer tub and the sus­
pension springs.
NOTE: // the "O" ring is to be reused, be ex­
tremely careful not to damage it during the
removal.
To assist in correctly positioning the tub, a
small indentation has been formed on the tub
support just above one of the tub brace
mounting areas. This is the left front tub brace.
When the tub is in proper position and ready
to be mounted to the tub support, the large
tub cover lock (on the side of the tub) should
be located directly above the indentation and
tub brace (See Page 7-16).
Remove the "O" ring and agitator once the
drive train is back in place.
The transmission assembly, when removed
as described, will have the related components
assembled to it. These related components
should be examined carefully before reinstall­
ing.
IMPORTANT
When installing the transmission, it is
necessary that the tub be located on the
tub support a certain way if all the
mounting holes are to be properly
aligned. This should be done before at­
tempting to mount the tub to the bear­
ing and sea! housing.
16009485-01 Section 7. Transmission And Related Components
7-15
©1999 Maytag Appliances Sales Company