SINGER 6606 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Windmg a bobbin is quick and easy when you follow the directions belov/. Always wind
the bobbin before threading the machine and needle.
« Push in indent (1) on hand wheel disc. This will stop the needle from
mosf'mg.
0
Place spool of thread on spool pin,
e Slide spool cap (2) firmly over rim of spool to prevent thread tangling,
o Lead thread from spool and snap Into thread guide post (3).
o Wind thread clockwise around front of bobbin winder tension disc (4),
« Pass
thresL6
end, from Inside, through small hole in rim of bobbin,
« Place bobbin on spindle and push it to the right
9
Holding thread end, step on speed controller to run machine until desired amount of ^read
is wound- (Winding stops automatically once bobbin is full.)
* Cut thread; push bobbin to the left and remove it from spindle.
• Trim thread end from top of bobbin.
9
Return hand wheel disc to sewing position by pressing on side opposite indent.