ADLINK HSL-4XMO - Manual (Page 103)

Motion Creator in LinkMaster 93
ALM Logic and Response mode: Select logic and response
modes of ALM signal. The related function call is
HSL_M_set_alm().
1. INP Logic and Enable/Disable selection: Select logic,
and Enable/ Disable the INP signal. The related function
call is HSL_M_set_inp()
2. ERC Logic and Active timing: Select the Logic and
Active timing of the ERC signal. The related function call
is HSL_M_set_erc().
3. EL Response mode: Select the response mode of the
EL signal. The related function call is HSL_M_set_el().
4. ORG Logic: Select the logic of the ORG signal. The
related function call is HSL_M_set_home_config().
5. EZ Logic: Select the logic of the EZ signal. The related
function call is HSL_M_set_home_config().
6. SD Configuration: Configure the SD signal. The related
function call is HSL_M_set_sd().
7. LTC Logic: Select the logic of the LTC signal. The related
function call is HSL_M_set_ltc_logic().
8. Buttons:
X
Next Axis: Change operating axis.
X
Save Config: Save current configuration to HSL-4XMO.ini.
X
Operate: Go to the operation menu, refer to section 5.3.4
X
Config Pulse : Go to the Pulse IO Configuration menu, refer
to section 5.3.3
X Back: Return to the main menu.
Pulse IO Configuration Menu
In this menu, users can configure pulse input/output and move
ratio and INT factor.