11 s1: switch setting for hsl slave id, Ting – ADLINK HSL-4XMO User Manual
Page 24
Advertising
14
Installation
2.11 S1: Switch Setting for HSL Slave ID
Figure 2-3: S1: Switch Setting for HSL Slave ID
Note:
Each HSL-4XMO occupies 4 HSL IDs. If using half duplex
mode, the occupied ID will be continuously from this setting.
For example, if you set the ID=1 then the occupied IDs will
be 1, 2, 3, 4. If using full duplex mode, the occupied ID will
be two ID steps in order. For example, if you set the ID=1
then the occupied IDs will be 1, 3, 5, 7.
2.12 JP1: Jumper Setting for HSL Communication
Speed Selection
Figure 2-4: JP1: HSL Communication Speed Selection Jumper Setting
Advertising