Subaru 2007 Tribeca User Manual

Page 113

Advertising
background image

2-16

Keys and doors

sound once, the turn signal lights will flash

once and the indicator lights will start

flashing rapidly. After rapid flashing for 30

seconds (standby time), the indicator

lights will then flash slowly (twice approxi-

mately every two seconds), indicating that

the system has been armed for surveil-

lance.

If any of the doors, (or the rear gate) is not

fully closed, an electronic chirp sounds

five times, the turn signal lights flash five

times to alert you that the doors (or the

rear gate) are not properly closed. When

you close the door, the system will auto-

matically arm and doors will automatically

lock.

T To arm the system using power

door locking switches

1. Close all windows.

2. Remove the key from the ignition

switch.

3. Open the doors and get out of the vehi-

cle.

4. Make sure that the engine hood is

locked.

5. Close the doors and the rear gate but

leave only the driver’s door or the front

passenger’s door open.

6. Push the front side (“LOCK” side) of

the power door locking switch to set the

door locks.

7. Close the door. An electronic chirp will

sound once, the turn signal lights will flash

once and the indicator light will start flash-

ing slowly (approximately once every two

seconds) to inform you that the system

has armed.

NOTE

y

The system can be armed even if the

engine hood, the windows and/or

moonroofs are opened. Always make

sure that they are fully closed before

arming the system.
y

The 30-second standby time can be

eliminated if you prefer. Have it per-

formed by your SUBARU dealer.

y

The system is in the standby mode

for a 30-second period after locking the

doors with the remote transmitter. The

security indicator light will flash at

short intervals during this period.
y

If any of the following actions is done

during the standby period, the system

will not switch to the surveillance state.

y

Doors are unlocked using the re-

mote transmitter.
y

Any door (including the rear gate)

is opened.
y

Ignition switch is turned to the

“ON” position.

„

Disarming the system

Briefly press the “

” button (for less

than two seconds) on the remote transmit-

ter. The driver’s door will unlock, an elec-

tronic chirp will sound twice, the turn sig-

nal lights will flash twice and the indicator

light will go off.

To unlock all other doors and the rear

gate, briefly press the “

” button a

second time within 5 seconds.

NOTE

If the interval between the first and sec-

ond presses of the “

” button (for

unlocking of all of the doors and the

rear gate) is extremely short, the sys-

200705

A3120BE-B.book 16 ページ 2006年5月30日 火曜日 午前9時32分

Advertising